Posts: 1,116
Threads: 0
Joined: Feb 2015
Reputation:
14
Machinists, Welders, Woodworkers, Fabricators, Gearheads ...
12-05-2017, 02:36 PM
Just bought a first house, so next years job is to first secure the garage (it's not a high end house) then slowly turn it into a workshop.
Among basic things like a sturdy bench, vice and storage I want to build a small/medium size CNC mill with about a 500x300 mm bed.
Posts: 1,370
Threads: 1
Joined: Jun 2013
Reputation:
20
Machinists, Welders, Woodworkers, Fabricators, Gearheads ...
12-06-2017, 03:52 AM
Quote: (12-05-2017 01:53 PM)General Stalin Wrote:
I like fixing, tinkering, and restoring various things. Definitely not a master of anything, but I do all my own mechanical repairs on my vehicles, have restored a couple of record players, dabbled in wood working/refinishing, most recently fabbed up a drawer for my studio desk to hold a MIDI keyboard.
Looking at a potentially very involved repair on my truck in the near future. It's been losing oil for a while and there have been drips on the ground below the engine for a while. Replaced the oil pan gasket and now the drips are gone but still pissing through oil (even worse than before actually). So I think I'm starting to narrow it down to maybe bad piston rings burning off my oil. If that is actually the case I'm going to need to pull my engine apart to fix it. Damn.
Run a compression test before you start pulling it apart. It could be a leak elsewhere or something like the turbo burning oil.
They who would give up essential Liberty, to purchase a little temporary Safety, deserve neither Liberty nor Safety- Benjamin Franklin, as if you didn't know...
Posts: 5,033
Threads: 0
Joined: Nov 2013
Reputation:
124
Machinists, Welders, Woodworkers, Fabricators, Gearheads ...
12-06-2017, 04:22 PM
My truck doesn't have a turbo but yeah a compression test would be a good idea. Thanks!
Posts: 756
Threads: 0
Joined: Sep 2016
Reputation:
4
Machinists, Welders, Woodworkers, Fabricators, Gearheads ...
12-07-2017, 05:17 PM
What kind of truck do you have ?
Posts: 2,099
Threads: 0
Joined: Jun 2014
Reputation:
116
Machinists, Welders, Woodworkers, Fabricators, Gearheads ...
03-07-2018, 02:28 PM
Any machinists able to ping me over PM? Advice/collaboration on a project.