rooshvforum.network is a fully functional forum: you can search, register, post new threads etc...
Old accounts are inaccessible: register a new one, or recover it when possible. x


The 'Ask a tradesman' thread

The 'Ask a tradesman' thread

How's the motor running mate?

They who would give up essential Liberty, to purchase a little temporary Safety, deserve neither Liberty nor Safety- Benjamin Franklin, as if you didn't know...
Reply

The 'Ask a tradesman' thread

Quote: (04-07-2019 01:53 PM)roberto Wrote:  

How's the motor running mate?

Like a top. Fuel pump fixed that previous issue 100%. Since then I have done some other work to the truck:

-Upper ball joints, both
-Lower ball joints, both
-Inner and outer tie rods, both
-Valve cover gaskets, both
-Oil sending unit

Still have an oil loss issue, and low pressure as well. The low oil pressure I'm pretty sure I know the cause of - likely bad O-ring in the pickup tube in the crank case. Small cheap part but a pain in the ass to get to and install. The leak could be a number of things, though I've been narrowing it down. For brevity's sake I think I'm just going to take the truck off the road for a week or two and yank the motor and fix all the issue and refurbish it.

2019 projects:

-Pull the motor and do a cleaning and partial rebuild/complete rebuild if necessary
-Replace worn out factory suspension with 4 new shocks all around and new coils in the rear
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)